To: | <tentec@contesting.com> |
---|---|
Subject: | [TenTec] Omni D low output |
From: | "Paul DeWitte K9OT" <k9ot@mhtc.net> |
Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
Date: | Sat, 21 May 2005 00:11:11 -0500 |
List-post: | <mailto:tentec@contesting.com> |
I think that it was Bob K4TAX that posted the original question about low output. My Omni C a few years ago had the same problem. I sent it to T T and the problem was the low level drivers (I think that is the correct term). Since it was 20 something years old at that time, I did not think that was too bad. Worked great after that. 73 Paul K9OT -- No virus found in this outgoing message. Checked by AVG Anti-Virus. Version: 7.0.322 / Virus Database: 266.11.14 - Release Date: 5/20/05 _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: [TenTec] Omni V.9 DB25 to DB9, Steve Baron - KB3MM |
---|---|
Next by Date: | [TenTec] test message, Larry Greenberg N5BEA |
Previous by Thread: | [TenTec] Entry level clatification, Larry Greenberg N5BEA |
Next by Thread: | [TenTec] test message, Larry Greenberg N5BEA |
Indexes: | [Date] [Thread] [Top] [All Lists] |