My Allen knob wrench mikes 0.0494 across flats.
-----Original Message-----
From: tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com] On Behalf Of Steve N4LQ
Sent: Saturday, February 26, 2005 10:04 AM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] 263 Remote VFO PTO
Wish I knew the exact size wrench but yes on most TT gear you must
remove
all knobs and front panel to access the screws holding the PTO on the
frame.
Steve Ellington
N4LQ@iglou.com
----- Original Message -----
From: "Howell, D. Haney" <howellh@winthrop.edu>
To: <tentec@contesting.com>
Sent: Saturday, February 26, 2005 9:40 AM
Subject: [TenTec] 263 Remote VFO PTO
>I have in hand the rebuild kit for the PTO in my remote VFO for the
Omni D.
>That's the good news. The bad is that I can't get the main tuning knob
off
>the front. I've tried every allen wrench and bristol I can find and
>nothing seems to fit.
>
> Also, must you dismantle the entire front panel to release the PTO
box?
>
> The TT instructions start with "remove the box from the radio".
>
> Thanks
>
> Haney
> K2XN
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|