TenTec
[Top] [All Lists]

Re: [TenTec] Jupiter + Studio One microphone settings

To: tentec@contesting.com
Subject: Re: [TenTec] Jupiter + Studio One microphone settings
From: N0KHQ@aol.com
Reply-to: tentec@contesting.com
Date: Sat, 11 Oct 2003 09:25:06 EDT
List-post: <mailto:tentec@contesting.com>
Set the rolloff at 100hz and the transmit band width to 3000. The will give 
you a 2900 transmit bandwidth. If people tell you your too bassy raise the 
roll-off up to say...200hz.

Dont expect the Studio One to perform miracles.....because it wont. To find a 
mic that works with your voice through the Jupiter or any other radio is 
almost impossible. Mics are not individually custom built. 

You can feed your audio into two sources on the Jupiter......through the 
front mic or through the rear accessory socket.

The best place to monitor your audio with head phones is through the rear 
accessory socket. use a good set of stereo headphones....something like Sony 
MCR-V600. What you will hear is pretty close to what is being received by other 
stations. Do not use the front phone jack.

73
John / N0KHQ / St. Louis 

Always on 17M
Antennas:
You can build 'em better than you can buy 'em.
Visit www. Hamuniverse.com - then click on Antennas
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>