[TenTec] Paragon II

[alfred.heyden@t-online.de (Alfred Heyden)]

Hello TT-fellows,
I run my Paragon II with a non-TT and non qsk amplifier. The rear
jacks TX OUT/ TX EN
are jumpered. I'm not quite shure if this is correct. Should I
remove the jumper?
The operator's manual tells me to leave this jumper in place for
all operations general not
using a RF linear. Means this to leave the jumper also in place
when using an non-qsk-amp?
I key the amp with the RELAY N.O. jacket.
Thanks for your hints.
With regards, Alfred, DL2JR