One of the minor complaints I had about my Argo was the difficulty in
tuning as compared to a digital rig. Since the Argo uses a PTO it does not
behave the same, you can't quickly dial about the band. However, I realized
that this was not a flaw but just the way it works. But I did make a
discovery that improves the situation. I realized one day that tuning the
Argo was not an enjoyable experience because the knob was too small! I did
an experiment. I went to the local hdw store (with the knob in my pocket)
and found a combination of plastic plumbing couplings that would press fit
over the knob, increase the diameter and still clear the existing switches
on the panel. It gave me a knob of about 2" in diameter. The difference was
rewarding. I found it easier to tune both cw and ssb signals. Now this is
really a kludge. What I would like to get is a real knob with a larger
diameter which extends clear of the panel before it gets bigger.
I could do this if I had a lathe to turn a piece of plastic to the
necessary diameters and a drill press to drill the shaft and set screw
holes and a tap to thread the set screw hole. But I don't.
I suppose I am looking to buy such an item/service. Can anyone help? I
don't suppose TT has such an item in their inventory?
Bill Ames
KB1LG
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|