Wondered if anyone could give me advice on this.
My paddle interface is sending nothing but di dah di
dah di dah or dit dit dit dit. I saw in the
troubleshooting section of the manual that this
usually means my older computer needs to have the dit
and day inputs tied to pin 14 through a resistor.
I'm using an old toshiba computer with windows 98 that
I boot to dos. I purchased the model 3 cw interface
from trlog that has the paddle interface built in and
I looked at it and it has the resistor across the
pins. This has worked for me for several previous
contests. I have had problems with the paddle
interface before but have been able to get it going
just by fooling with the interface a little.. pulling
and plugging cables, etc, and all the sudden it would
start up!
Any thoughts on what to look at?
Thanks for any help,
Gary
Gary Slagel/N0SXX
Lakewood, CO
http://marina.fortunecity.com/sanpedro/351
____________________________________________________________________________________
Cheap talk?
Check out Yahoo! Messenger's low PC-to-Phone call rates.
http://voice.yahoo.com
_______________________________________________
Trlog mailing list
Trlog@contesting.com
http://lists.contesting.com/mailman/listinfo/trlog
|