Known bug in 6.79, but its previous manefestations didn't seem to be unique to
Canadian stations.
Look at previous postings by me and W9RE over the last 2 years for details.
This broke sometime after 6.69 - I still use 6.69 due to this bug.
73,
Steve, N2IC
Bob Wanderer wrote:
> Using 6.79. No changes to logcfg.dat from last time.
> Didn't have this happen before.
>
> This happened every time (but once) when I worked a Canadian
> station and a couple or three times or so working a W/K. No
> rhyme or reason that I could ascertain. I keep the bandmap
> active even though I don't use packet. This allows me to
> identify stations I've worked (or not) as I pass by on
> successive band trolls. I am 99+% S&P. Anyway, after I
> worked and logged a Canadian station, moved on and came
> back, the callsign would not be displayed in the callsign
> window. Either nothing or one or two alphanumeric
> characters were displayed, but the cursor was in the middle
> of the field. (This also occurred immediately after the QSO
> within the 200Hz guard band as I moved off frequency.) His
> callsign was in the dupe or similar call area, the callsign
> was blinking in the bandmap, and his name and Canada was in
> the area to the right of the callsign window. The same
> scenario was seen with the few W/K stations. For probably
> 99+% of W/K calls, this malady did not occur.
>
> Help!
>
> Thanks and 73,
> Bob AA0CY
>
> _______________________________________________
> Trlog mailing list
> Trlog@contesting.com
> http://lists.contesting.com/mailman/listinfo/trlog
>
>
_______________________________________________
Trlog mailing list
Trlog@contesting.com
http://lists.contesting.com/mailman/listinfo/trlog
|