I had used my KRC2 band-decoder unit to switch between
main and auxiliary receiving antennas when the loss of
communication occurred. I must have put my thumb down on
two buttons at once and generated some other command. It
must be equivalent to "turn off the comm port".
When I checked it, I found the comm port at OFF, and reset it
to ON. Everything is working again. I wrote myself a note
in my TR manual in case I do this again in the future :-)
See you all in SP tonight.
73, Bob N6WG
-----Original Message-----
From: trlog-bounces@contesting.com
[mailto:trlog-bounces@contesting.com]On Behalf Of Bob Tellefsen
Sent: Saturday, December 27, 2003 8:15 AM
To: TR Log
Subject: [Trlog] Loss of freq input
I was working the Stew Perry this morning and suddenly
my frequency display from the rig disappeared. I've tried
powering off and back on both the rig, a K2 with KI02 interface,
and my computer. No joy.
Any suggestions?
Thanks and 73, Bob N6WG
_______________________________________________
Trlog mailing list
Trlog@contesting.com
http://lists.contesting.com/mailman/listinfo/trlog
_______________________________________________
Trlog mailing list
Trlog@contesting.com
http://lists.contesting.com/mailman/listinfo/trlog
|