Is it possible to set the base IO address for serial ports 1 thru 4 in
TRLog? I can enable and set the base IO for serial ports 5 and 6.
Enabling ports 5 and 6 is working just fine with an 8 serial port Multi
Port PCI card I have, but this special multi port serial card has non
standard IO port addresses for each port.
So basically, I need to know if there is a config command for serial
ports 1 thru 4 like the existing serial port 5 and 6 commands:
SERIAL 5 PORT ADDRESS XXX
SERIAL 6 PORT ADDRESS XXX
(I already tried the obvious, TRLog gives a config error, SERIAL
1(2,3,4) PORT ADDRESS XXXX doesn't work.)
OR are the base IO ports for ports 1 thru 4 HARD coded in TRLog to
standared defaults 0x3f8, 0x2f8 etc...? (or maybe TRLog is reading them
from the BIOS) It appears that I can only customize the port addresses
for ports 5 and 6 with the above commands. (which works great, but I
only get two ports with my funky/groovy PCI multi port card)
If the base IO address/ports for SERIAL PORTS 1 thru 4 can be manually
configured in TRLog, I will have reached serial port nirvana! If not,
it sure would be a nice feature for an update someday. ;)
Regards
mg NG7M
--
Max Matthew George NG7M
mailto:ng7m@qrq.com
--
FAQ on WWW: http://www.contesting.com/trlogfaq.html
Submissions: trlog@contesting.com
Administrative requests: trlog-REQUEST@contesting.com
Problems: owner-trlog@contesting.com
Feature Wishlist: http://web.jzap.com/n6tr/trwish.html
|