On Fri, Oct 27, 2017 at 3:38 PM, <K8UT@charter.net> wrote:
> Nope, I did not give up on the project.
>
> I run rpiFSK here for FSK RTTY from 2Tone or MMTTY via a Raspberry Pi 3.
> Have shared the software and assisted a small handful of hams with running
> it... but it proved to be somewhat difficult to get configured, and I am
> afraid to "advertise" it too heavily because I am unable to provide the
> support that folks might need. At this stage I would have to classify rpiFSK
> as poorly suited for civilians. ;-)
>
Decided to try to get an Arduino Nano clone with the non-counterfeit
FTDI chip (so I don't have to play driver games). The RPi remains
idle. :-)
Anyone know of a tutorial on getting COM ports to play nice with one
another on W10? I have a 4-port Siig card (FTDI) and a couple of
USB->RS-232->TTL adapters for Icom CI-V (Prolific) and they don't seem
to want to play nicely together. I've got a new hub coming and will
separate them out since I think they might all be unhappy on the same
hub. Also need to scour the NUC docs to see which physical USB
ports are on which buses, I guess, just so I know where things are.
--
Peter Laws | N5UWY | plaws plaws net | Travel by Train!
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|