RTTY
[Top] [All Lists]

[RTTY] 2Tone Chirp

To: rtty@contesting.com
Subject: [RTTY] 2Tone Chirp
From: David G3YYD <g3yyd@btinternet.com>
Date: Mon, 16 Dec 2013 10:27:38 +0000
List-post: <rtty@contesting.com">mailto:rtty@contesting.com>
As you can see I have joined this reflector.

The start up sequence of 2Tone is just as Chen, W7AY, describes. This is intentional as I will explain.

When receiving using 2Tone in normal mode it asses the envelope value of both the mark and space tones. It uses this along with its noise assessment to generate a threshold value for each tone. These threshold values are used as part of the way 2Tone works out whether mark or space is being received at any instance in time.

At the moment a new transmission starts up 2Tone receive envelope and noise values will be incorrect as they will either be a value of the previous transmission or the value of the noise/QRM being received. In order to optimise 2Tone decode there is a need to send a space tone and a mark tone before characters are sent.

Being that mark tone is required to ensure the asynchronous decoder is ready for the start bit of the first character then the logical sequence is space tone for one character time; setting the space threshold value and mark noise value. This is then followed by mark tone for one character time setting the mark threshold value and space noise value and resetting the asynchronous decoder to wait for first start bit (one bit time of space tone).

Most (all?) other means of sending RTTY normally start with a long, in many cases unnecessary long, mark tone and then sends the first character. This means the space tone threshold will be in error. But 2Tone is a bit more sophisticated. It deliberately delays assessment by one character time so it can also use information from the second sent character to establish a space (and improved mark) threshold value for the first character. So not all is lost but for best results the 2Tone sequence is that fastest you can go and get the best decode accuracy.

As Chen says 2Tone transmission has a slow amplitude ramp up at the start and ramp down at the end of transmission so there are no clicks to cause QRM to other band users. Very few AFSK implementations do this and no rig based FSK does it causing unnecessary QRM on adjacent channels.


73 David G3YYD


_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty

<Prev in Thread] Current Thread [Next in Thread>