Open up the N1MM Logger.ini file and look for this line:
Dig1RxWindowMMTTYPath1=
It will list your path after the = just change it there and save the file.
Make sure N1MM is not running when you make the change..
73 Rick N2AMG
-----Original Message-----
From: RTTY [mailto:rtty-bounces@contesting.com] On Behalf Of
Ktfrog007@aol.com
Sent: Tuesday, March 26, 2013 7:45 PM
To: rtty@contesting.com
Subject: [RTTY] Typo in N1MM Receive window 1
Hi,
I am currently porting all my ham radio software to a new computer - quite a
job.
I made a small error which isn't fatal but is an annoyance and offends my
sensibilities.
While setting up N1MM for RTTY I was activating my first receive only
screen, Rx Window 1, I typed in the MMTTY address instead of browsing for
it and made a typo.
Now that window will never re-open so I can fix it. I went on and made an
Rx 2 window properly, but I'd like to clean up the little mess I made, but
I don't know how to get back into the Rx 1 window.
Any ideas? I'm hoping for help here rather than joining any more groups.
73,
Kermit, AB1J
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|