Hi Kermit
You can go to config/config ports.../digital modes tab. There you can set
the path to MMTTY. 73
Tom W7WHY
Hi,
I am currently porting all my ham radio software to a new computer - quite
a job.
I made a small error which isn't fatal but is an annoyance and offends my
sensibilities.
While setting up N1MM for RTTY I was activating my first receive only
screen, Rx Window 1, I typed in the MMTTY address instead of browsing for
it
and made a typo.
Now that window will never re-open so I can fix it. I went on and made an
Rx 2 window properly, but I'd like to clean up the little mess I made, but
I don't know how to get back into the Rx 1 window.
Any ideas? I'm hoping for help here rather than joining any more groups.
73,
Kermit, AB1J
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|