RTTY
[Top] [All Lists]

[RTTY] Rigblaster & N1MM Help

To: <RTTY@contesting.com>
Subject: [RTTY] Rigblaster & N1MM Help
From: "KE1JF-Tom" <ke1jf@cox.net>
Date: Sun, 18 Jul 2010 15:04:45 -0400
List-post: <rtty@contesting.com">mailto:rtty@contesting.com>
Hello All,

A few weeks ago my MFJ-1279 quit working so I replaced it with a Rigblaster 
Plus. It connected right up in place of the MFJ as far as Keying my TS-2000 in 
FSK. For receiving the RB is not used so I put an isolation transformer ( radio 
shack 273-1374, 1:1 )  in the audio line & plugged into my mic. in on my 
computer as before but when I start N1MM I get an Err 4 Opening Recording 
Device & no waterfall. If I unplug the audio line from the computer & plug it 
back in the error message goes away & I get a waterfall & print as normal until 
I make a contact. As soon as I hit enter to log it the waterfall goes away & I 
get the error back but unplugging & plugging the audio line to the computer 
clears the error up & the waterfall returns for another contact but the error 
repeats after each contact. I tried the line in & tried without the isolation 
transformer but no difference. MMTTY seems to be working normally as far as I 
can tell & at this point I could use any ideas. Has anyone el
 se seen this before or have any ideas ?

Tnx. in advance & 73,

Tom, KE1JF
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty

<Prev in Thread] Current Thread [Next in Thread>
  • [RTTY] Rigblaster & N1MM Help, KE1JF-Tom <=