Yo.....
Is anyone out there using NA with a B&W monochrome monitor?
I have one in my NA network and cannot read the screen properly (I know,
buy a cheap VGA monitor).........
How do I get the grays such that I can see the different windows without
losing track of them...several things I know what keys to push by
experience with the software but cannot see it on the screen!
While thumbing my manual I couldn't find where the instructions for use
with a monochrome screen were........
In the config I see monitor setup with F9 to set to the current monitor but
that changes nothing........
If you have been down this road pls share your solutions, thanks!
73,
Jim, K4OJ
k4oj@ij.net
LESS THAN ONE WEEK until my favorite contest, Sweepstakes CW. Make sure
you work me so you will not miss the elusive South Floirda multiplier!
Proud member of the Florida Contest Group - visit our website at:
http://www.4w.com/deemer/fcg.htm
The Florida Contest Group sponsors the Florida QSO Party, check out the FQP
website@:
http://home1.gte.net/wd4ahz/fcg/ssqp.htm
--
Submissions: na-user@contesting.com
Administrative requests: na-user-REQUEST@contesting.com
WWW: http://www.contesting.com/datom/
Questions: owner-na-user@contesting.com
|