It is just the radio, when I get it back to the shop and connected to a very
nearby AP, it will recieve but not transmit. We are using outdoor UTP and
running a seperate 14 Ga. solid copper ground.
Joe
----- Original Message -----
From: "Caleb Carroll" <karlnet@pathcom.ca>
To: "Karlnet Mailing List" <karlnet@WISPNotes.com>
Sent: Thursday, July 29, 2004 10:07 AM
Subject: Re: [Karlnet] repeted Radio failure.
Is it just the radio card that is dieing or the whole KN-105. Also, are
you using shielded or standard Cat-5 cable and what length?
*********** REPLY SEPARATOR ***********
On 2004-07-29 at 9:20 AM joe wrote:
>I have a location that seems to destroy radios. I'm using KN-105 w/PoE
>and
>a 12v regulator in an integrated 19 dBi antenna and SMC 200mw radio(have
>also tried Ecomm's 200mw). The antenna is mounted on a composite shingled
>roof and is grounded to the incoming power conduits for the building. The
>company uses large amounts of power, I see a gauge on the power panel that
>continuously reads in excess of 250A (440V). There has been some
>lightening
>in the area, but this location seems to toast radios even when there is no
>lightening. Recently every other day.
>
>Anyone have experience/suggestions with/for this sort of problem?
>
>Joseph Conrad
>Mountain Computer Wizards, Inc.
>
>
>_______________________________________________
>Karlnet mailing list
>Karlnet@WISPNotes.com
>http://lists.wispnotes.com/mailman/listinfo/karlnet
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
|