Dan,
This is easily configured in software (ie Karlnet can do this). The LEDs
are just hanging off the IP2022, what we have done on ours is configure
one LED as a 'Wireless Link Up', do note this is not running Karlnet's
s/w though. It was a five minute job.
Regards
Eden
> -----Original Message-----
> From: karlnet-bounces@WISPNotes.com
> [mailto:karlnet-bounces@WISPNotes.com] On Behalf Of Dan Metcalf
> Sent: 06 August 2003 01:46
> To: 'Karlnet Mailing List'
> Subject: RE: [Karlnet] low cost cpe's - wish list -0
>
>
> On the current ubicom systems, you can't tell if you have a
> link unless
> you log into the unit, the WLAN light always seems to flash
> regardless?
>
> --
> [This E-mail scanned for viruses by Declude Virus]
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
|