Can someone please tell me how to configure a KN AP on an AP-1000 to do
routing and allow users to connect? I'm having a devil of a time. I have
the following routing set up:
10.10.11.2 255.255.255.252 Direct 3
209.49.136.193 255.255.255.192 Direct 1
10.10.13.1 255.255.255.0 Direct 2
Default route is 10.10.11.1.
DHCP Setup:
Starting address: 10.10.13.2
Ending Address: 10.10.13.254
Default Router: 10.10.13.1
Default Router Subnet: 255.255.255.0
Do I need to setup outgoing NAT now? And if so, how?
IP traffic is passing through the router fine, but when I connect to this AP
(interface two above), I can't pass any traffic through it.
Thanks
bill
|