Well Terry, your one up on me. I got the driver to load, chose TC instead of
access point, the key code, ect. but cant associate with the AP1000. Does the
network name have any value in TC mode?
---------- Original Message ----------------------------------
From: "Terry Bomersbach" <terryb@the-cia.net>
Reply-To: isp-wireless@isp-wireless.com
Date: Fri, 10 May 2002 20:46:55 -0500
>FWIW, remind me to write one up for the TC NDIS for WinNT once I get it
>figured out. The card is X'd out in the Client Manager in TC mode and
>associates just fine in 802.11b mode but doesn't pass packets at all. I can
>see the AP but can't go anywhere. When I try to connect to the AP or OR
>using the config.exe I get an error about an invalid IP address or something
>about not being able to contact 0.0.0.0 (not exact wording of course).
>
>
>-----Original Message-----
>From: Bill Fisher <fisher@akorn.net>
>To: isp-wireless@isp-wireless.com <isp-wireless@isp-wireless.com>
>Date: Friday, May 10, 2002 8:19 PM
>Subject: Loading Karlnet Firmware to AP-1000
>
>
>>
>>FWIW, I have written a short how-to article on how to load Karlnet to an
>>AP-1000 and published it on WispNotes.com. You can also post your comments
>>to the article if you find something wrong or would like to add something
>of
>>interest.
>>
>>http://www.wispnotes.com/articles/12
>>
>>Hope this helps someone.
>>
>>Best,
>>
>>Bill Fisher
>
>
>
>___________ The ISP-WIRELESS Discussion List ___________
>To Join: mailto:join-isp-wireless@isp-wireless.com
>To Remove: mailto:remove-isp-wireless@isp-wireless.com
>Archives: http://isp-lists.isp-planet.com/isp-wireless/archives/
>
--
Eric L. Johnson
WarpSpeed Internet
1-361-563-3742
--
|