Rick,
I've seen this before, it is a networking issue. Can you describe your network?
By chance does
Station 2 have a serial link and an ethernet connection?
Ted W4NZ
-----Original Message-----
From: ct-user-bounces@contesting.com
[mailto:ct-user-bounces@contesting.com]On Behalf Of Rick Saeger
Sent: Sunday, February 26, 2006 10:04 PM
To: 'Rick Saeger'; ct-user@contesting.com
Subject: Re: [ct-user] double callsigns
I get the same result even if I run it in the MS category .
-----Original Message-----
From: ct-user-bounces@contesting.com
[mailto:ct-user-bounces@contesting.com] On Behalf Of Rick Saeger
Sent: Sunday, February 26, 2006 8:03 PM
To: ct-user@contesting.com
Subject: [ct-user] double callsigns
I just installed CTwin 10.02.008.
Running in the M2 mode for the arrl dx contest I get double callsigns on
station 2 when I enter one callsign in station 1. I also receive double
packet spots/double gab info when I enter them from station one to
station two. The summary sheet is the same on both stations and is
correct.
The information from station 2 to station one is fine.
Any ideas?
Thanks,
Rick K3OO
_______________________________________________
CT-User mailing list
CT-User@contesting.com
http://lists.contesting.com/mailman/listinfo/ct-user
CT on the web: http://www.k1ea.com/
_______________________________________________
CT-User mailing list
CT-User@contesting.com
http://lists.contesting.com/mailman/listinfo/ct-user
CT on the web: http://www.k1ea.com/
_______________________________________________
CT-User mailing list
CT-User@contesting.com
http://lists.contesting.com/mailman/listinfo/ct-user
CT on the web: http://www.k1ea.com/
|