I have just upgraded to a Dell Pentium II 300 with Win98 (I know I'm
scrounging) which has only one Com port on the mother board. I added a PCI
board with two ports. This works okay in CTWin where Com 3 is IRQ 9 I/O
FCC0 and Com 4 is IRQ 9 I/O FCC8. However, I cannot get the comtsrs to
address the PCI ports in CT_DOS. I have tried a number of combinations of
IRQs and Addresses on the command line but still no joy. Command lines I'm
using are:
comtsr1 -P1 -B4800 -I4 -A3f8 - works okay on Com1
comtsr3 -P3 -B4800 -I9 -AFCC0 - loads but no response
Do the comtsr drivers only address the usual 4 on-board locations or is
there a way to have them find these PCI ports?
Thanks for your help,
73s
Bill
NU6I
bill@spickler.net
_______________________________________________
CT-User mailing list
CT-User@contesting.com
http://lists.contesting.com/mailman/listinfo/ct-user
CT on the web: http://www.k1ea.com/
|