Guys,
Here is my experience with V9.37 in several areas.
1) The radio timeout "problem". Yes it prints the error message. I get
it when I send or grab a spot. It doesn't affect anything as far as I
can tell. The log shows all the correct frequencies. Using a Kenwood
TS-450.
2) I was running a single radio for a while as radio 2. Guess what.
When I tried to spot something, no frequency showed up for either the
recieve frequency or QSX frequency. Nada just a blank. I switched
things back to so the radio was radio 1 and it worked OK. Anybody else
notice that?
3) The ctrl-> and then scrolling to a spot is very inconvenient. I
understand why it was done. However, why not just use the same logic
and let the alt F3 send you to the box for scrolling. Alt-F3 to get you
there, alt-F3 to return. Why anything else? Alt- F3 doesn work now to
grab spots anyhow.
4)It was reported that splits were not properly spotted in this
version. I initially had troubles with this but only when the B was the
primary VFO I was tuning with and VFO A was the xmit frequency.
Reversing this solved the problem. Though I swear it only worked
properly after getting out of CT and back into it. Radio is TS450.
I wonder when the next version is due out and if these kinds of things
will be addressed.
Brian/K3KO
--
Submissions: ct-user@contesting.com
Administrative requests: ct-user-REQUEST@contesting.com
WWW: http://www.contesting.com/ct/
Questions: owner-ct-user@contesting.com
|