ke6ber@usa.pipeline.com wrote:
>
> Ok, I've got things set up, and here's the situation/problem.
>
> I am using a 386 with an Advantage serial card that has a db9 9 pin
> connector for the serial port. I am running this to the IF-232, and then
> into a Kenwood TS-450. Here's the problem. CT will set the radio's
> frequency, but it won't read the frequency from the radio. When I change
> bands on cT, the radio changes bands, but not vice versa. It seems that
> there is info getting to the radio, but none getting back to the computer.
> Any suggestions? Thanks in advance
>
> Al, KE6BER/1, ke6ber@usa.pipeline.com
>
> --
> Submissions: ct-user@ve7tcp.ampr.org
> Administrative requests: ct-user-REQUEST@ve7tcp.ampr.org
> WWW: http://www.ve7tcp.ampr.org/Software/ct
> Questions: owner-ct-user@ve7tcp.ampr.orgI had the same problem
> with my Kenwood TS-850S/AT. I was using version
9.0 and when I changed to version 9.27 the problem went away. You didnt
say what version you are using, but before doing anything, try version
9.27.
Joe K0BX
--
Submissions: ct-user@ve7tcp.ampr.org
Administrative requests: ct-user-REQUEST@ve7tcp.ampr.org
WWW: http://www.ve7tcp.ampr.org/Software/ct
Questions: owner-ct-user@ve7tcp.ampr.org
|