------------------Reply to mail dated 11-FEB-1993 07:19:12.28------------------
>Problem: CT (ver 8.21) is interfacing both IC761s and IC765s without
>errors. The interface is by J-Com. Yaesu says I have the only EPROM
>update and this was installed. The FT1000 is successfully controlled
>by other software. The Alt-F3 command does not work with CT, the
>timeout error message appears. The Alt-F4 command DOES work, but
>sluggishly. The CAT System light illuminates each try with Alt-F3.
Yaesu has a fix for this problem. The FT1000/JCOM product need a 2.7K from
pin 1 to pin 2 of the Yaesu din connector. Contact Chip Margelli at Yaesu if
you need further details. - Ken
---
73 - Jim AD1C
|