I must be subscribed to the wrong list. I didn't know this was only for
antenna models, what a surprise, but then again, I've only been subscribed for
about 2 years now, and seen maybe 10 messages go by the entire time.
If it's for modeling, why not make a model then talk about it?
How about this to get it started (and I am not so good of a model maker).
Basically, a 40m 4sq, sitting on the ground but using the ~70ft mast to hold
it, they slope a littel inward. I'm sure it could be tweaked to make it
much better. I can send the entire model if desired.
Paul, kg7hf
EZNEC Demo ver. 5.0
Offset Fed Yagi -Uda for QEX 2/18/2009 12:56:36 PM
--------------- WIRES ---------------
No. End 1 Coord. (ft) End 2 Coord. (ft) Dia
(in) Segs Insulation
Conn. X Y Z Conn. X Y
Z Diel C Thk(in)
1 GND 0, 0, 0 0, 0, 70
#14 1 1 0
2 GND 15, 0, 0 7.7, 0, 33
#14 5 1 0
3 GND -15, 0, 0 -7.7, 0, 33
#14 5 1 0
4 GND 0, 15, 0 0, 7.7, 33
#14 5 1 0
5 GND 0, -15, 0 0, -7.7, 33
#14 4 1 0
Sources:
Wire # % from E1 Phase
2 0 0
3 0 -90
4 0 -90
5 0 180
_______________________________________________
Antennaware mailing list
Antennaware@contesting.com
http://lists.contesting.com/mailman/listinfo/antennaware
|