The intent was to reduce the amount of circulating current in the trap at the
operating frequencies. However, this also changes the placement of the trap,
the trap component values and the wire lengths involved for the same two
frequencies. The pattern of the antenna on the higher frequency changes some
because there is more current on the higher frequency in the outer sections.
Very tricky stuff. Can be modeled in EZNEC for sure and probably other
programs.
----- Original Message -----
From: "David Gould" <dave@g3ueg.co.uk>
To: <antennaware@contesting.com>
Sent: Friday, November 16, 2007 3:19 PM
Subject: [Antennaware] Trapped dipoles
I thought that a conventional 80m/40m trap dipole had the trap
resonant at 40m, I have now read a number of different fragments of
information that say that this is not the best approach and that the
trap should be resonant somewhere between the two desired frequencies.
I want to build a trap dipole for 40m and 30m. There are a couple of
things I don't understand...
Does it matter what the trap resonant frequency is?
Does the trap resonant freq affect the "inner" length of the dipole
from feed point to the trap to give resonance on the higher
frequency ( Trimming the outer length to the lower frequency would
be straightforward)
Any help or links to some detailed description would be appreciated.
73,
Dave, G3UEG
_______________________________________________
Antennaware mailing list
Antennaware@contesting.com
http://lists.contesting.com/mailman/listinfo/antennaware
_______________________________________________
Antennaware mailing list
Antennaware@contesting.com
http://lists.contesting.com/mailman/listinfo/antennaware
|