All of this information is still available online from the Internet
Archive Wayback machine.
73 Bill W4WHW
On 6/2/24 04:51, Ulf (SM0NOR) wrote:
Is it the "WD7S PRODUCTIONS HIGH VOLTAGE POWER SUPPLY BOARD HV-2" you are
looking for?
I have the pdf. I managed to download most of the stuff by wayback-machine a
few years ago.
73 - SM0NOR
________________________________
Från: Amps<amps-bounces@contesting.com> för jim.thomjim.thom@telus.net
<jim.thom@telus.net>
Skickat: den 31 maj 2024 15:58
Till:amps@contesting.com <amps@contesting.com>
Ämne: [Amps] WD7S lack of HV circuit ?
WD7S, on one of his boards he sold, was made to shut things down in the
event of loss of B+.
If I remember correctly, it resembled a mess of series resistors, like you
would use to meter HV, (without the meter), and an extra smaller value
resistor, in series at the cold end. The V drop across the small value
resistor was like 5-7 vdc.... and was applied to the rest of the circuit.
When the B+ dropped below a given threshold, the circuit tripped, and
kicked the amp offline...like opening off the keyline etc. I think it used
a spt, or dpdy mech relay..that was always operated, with B+ turned on. I
think the coil was opened off when the circuit tripped.
I can't find the original schematic for this board anywhere.
Does anybody have any info on it ?
Jim VE7RF
_______________________________________________
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|