On 07/04/15 04:00, "Jim Thomson" <jim.thom@telus.net> wrote:
[....] With the correct flow rate into a GS35B, oil temps should not be an
issue,
provided that a correct size rad is used, along with an expansion tank...aka
de-gas bottle, plus pump for the job, etc, etc.
I have settled on two automatic transmission coolers in series. Each is
393x254x30 mm. Refrigerant drier, stainless pipe + swagelok fittings,
7m head brass pump.
What is the de-gas bottle for?
I was going to vacuum the system out and charge it refrigeration-style.
Vacuum out all the air, purge with nitrogen, vacuum out again, fill with
oil, apply heat and hold vacuum on for 24 hours to de-gas, add +15psig
nitrogen and cap it and seal it.
Steve
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|