Morning Chris,
I know Dominic is using Vdc on the filament, so other guys in France are
using those power supply or PC power supply to feed filament and relays ,
that's the reason that I was asking.
Any special care when feeding with Vdc?
2015-02-04 10:32 GMT+00:00 Chris Wilson <chris@chriswilson.tv>:
>
>
> Hello Nuno,
>
> On Wednesday, February 4, 2015, you wrote:
>
> > Hi,
>
> > Me too.
>
> > I would like to know the pros and cons of running the filaments of an
> GS-35
> > with Vdc , you can get small power supply of 15, 24 or 30Vdc at 10A, by
> > around $30 some with 3 way out, you can run 1 or 2 tubes, and relays,
> > separately this is far more cheap than making one or to Vac
> transformer(s)
> > for the tubes and Vdc for the relays.
>
> > Any commends?
>
>
> Dominic, http://f1frv.free.fr/ uses switch mode DC supplies for many
> of his big amp filament supplies. I am doing the same with a couple of
> projects, I don't expect issues.
>
>
>
>
>
>
>
> --
> Best regards,
> Chris mailto:chris@chriswilson.tv
>
>
--
*73 Nuno CT2IRY*
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|