I thought it also provided bias for the tubes. I used the sting of diodes on
mine. I got help from VE7RF.
73
Dave N4XYZ
Sent from my iPad
On Jul 25, 2013, at 3:24 PM, Paul Baldock <paul@paulbaldock.com> wrote:
> Yes, I forgot about alc, which I also don't use.
>
> - Paul
>
> At 11:52 AM 7/25/2013, Jim W7RY wrote:
>> And provide the ALC voltage. If you don’t use ALC (which I don't) then you
>> can remove them.
>>
>> 73
>> Jim W7RY
>>
>>
>> -----Original Message----- From: Paul Baldock
>> Sent: Thursday, July 25, 2013 10:41 AM
>> To: Ed K0KL ; amps@contesting.com
>> Subject: Re: [Amps] L4B Caution
>>
>> I suggest you remove the bleeder resistors. They serve no purpose
>> other than to speed up the bleed down when you turn the amp off. They
>> create a lot of unnecessary heat in the supply.
>>
>> - Paul KW7Y
>>
>>
>>
>> At 10:32 AM 7/25/2013, Ed K0KL wrote:
>>> I had a bad experience when working on an L4B for a pal. The bleeder
>>> resistor mounting
>>> scheme proved to be a little poor (unusual for Drake). When reinstalled,
>>> one of the resistors
>>> shorted to the mounting screw.
>>> This bleeder is held in place by a screw that goes through the center of
>>> the resistor. Mica slices
>>> insulate the ends (chassis and screw head). Only thing is the resistor
>>> arced through the ceramic
>>> base material. So I used glass tape to insulated the screw on the
>>> reinstalled components. This
>>> provided better spacing to the center of the screw.
>>> Note- I replaced the resistors, having the same thing reoccur. Only with
>>> the use of the tape did
>>> the thing calm down. Ordinary electrical tape won't work as it will melt
>>> caused by the heat of
>>> the resistors.
>>>
>>> Anyway, that was some time ago, the amp is going strong. Except for a
>>> rather weak plate
>>> transformer, this puppy will no doubt last several lifetimes.
>>> _______________________________________________
>>> Amps mailing list
>>> Amps@contesting.com
>>> http://lists.contesting.com/mailman/listinfo/amps
>>
>> _______________________________________________
>> Amps mailing list
>> Amps@contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|