> Well, I just finished the cover for my power supply. Removed the clear
> plastic from the
> aluminum sheet, and it is beautiful -- except for the blue printing that
> indicates the
> alloy, etc.
> How do you get this off? I've tried 91% isopropyl alcohol and various
> petroleum-based
> solvents without success. I would hate to use anything abrasive because then
> I would have
> to polish the whole thing to make it look nice again. I hope there is
> something I can buy
> at the hardware store!
> I don't understand why the manufacturer didn't put the printing on the
> unprotected side.
23/01/2013 00:14
If they use the same marker as here in the UK cellulose thinners gets
it off. I am a race car engineer and I use a lot of aluminium in sheet
and other forms, that's what works on ali sheet here. Good luck!
--
Best Regards,
Chris Wilson.
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|