----- Original Message -----
From: "Tim Duffy K3LR" <k3lr@k3lr.com>
To: "'Charles Bibb'" <zedkay@telepak.net>; <amps@contesting.com>
Sent: Saturday, June 30, 2012 4:48 PM
Subject: Re: [Amps] addendum to 8877 plate voltage post
> Hello Charles:
>
> I have had no trouble running 4100 VDC for plate voltage on the 8877.
>
> There are guys that run close to 5 KV.
Even Six!
>
> 73,
> Tim K3LR
>
> -----Original Message-----
> From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com] On
> Behalf Of Charles Bibb
> Sent: Saturday, June 30, 2012 4:37 PM
> To: amps@contesting.com
> Subject: [Amps] addendum to 8877 plate voltage post
>
>
> Forgot to add this in my last post about high 8877 anode voltage:
>
> I've considered a "buck" transformer on the main transformer
> primary. I only need to "buck" the input a few volts (less than 20).
>
> Is this worth the trouble? Or should I just run it a tad high?
>
> 73,
> Charles - K5ZK
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|