I have had recurrent trouble with filament pins coming unsoldered in my
SB-220 during heavy contest operation, even though I have the
replacement Harbach fan that is supposed to move something like 30% more
air. I recall, years ago, reading that a lot of the heating might be
due to relatively high resistance between the pins and their socket
clips. The same author, if I remember right, also opined that the
heating would, over time, cause the clips to lose their temper,
aggravating the problem.
I went in and swapped two of the grid clips for the filament clips on
each socket, polished the pins and the inside of the clips, and put a
small fan on top of the tube compartment to help move air through.
Haven't melted a filament pin since. Fingers crossed.
73, Pete N4ZR
The World Contest Station Database, updated daily at www.conteststations.com
The Reverse Beacon Network at http://reversebeacon.net, blog at
reversebeacon.blogspot.com,
spots at telnet.reversebeacon.net, port 7000 AND now
at arcluster.reversebeacon.net port 7000
On 12/6/2011 4:32 PM, Carl wrote:
> The SB-220 cools the filament pins.
>
> Carl
> KM1H
>
>
> ----- Original Message -----
> From: "Bill Fuqua"<wlfuqu00@uky.edu>
> To: "John King"<k5pgw@yahoo.com>;<amps@contesting.com>
> Sent: Tuesday, December 06, 2011 9:15 AM
> Subject: Re: [Amps] Replacing 3-500Z tubes with 4-400A tubes
>
>
>> One possible issue with the 4-400A is that it has a metal shield around
>> the glass seals on the base.
>> The cross flow cooling used in some amplifiers does not work well and an
>> additional fan
>> may be need to cool the seals.
>> Maybe someone can comment on this that have had personal experience
>> making the conversion.
>> 73
>> Bill wa4lav
>>
>>
>>
>> At 04:20 PM 12/4/2011 -0500, John King wrote:
>>> I have several very good 4-400 A tubes and have replaced a pair of bad
>>> 3-500Z tubes with a pair of 4-400A tubes in a Heath SB 220 amp.
>>>
>>> I have noticed much lower resting current being drawn when keyed up. I
>>> have noticed about 200 watts less power output with 100 watts drive. The
>>> 4-400A tubes are as new.
>>>
>>> I made no changes to bias or other parameter adjustment. I would
>>> appreciate the benefit of your knowledge and experience regarding the tube
>>> substitution. Thanks and 73, John, K5PGW
>>> _______________________________________________
>>> Amps mailing list
>>> Amps@contesting.com
>>> http://lists.contesting.com/mailman/listinfo/amps
>> _______________________________________________
>> Amps mailing list
>> Amps@contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>>
>>
>> -----
>> No virus found in this message.
>> Checked by AVG - www.avg.com
>> Version: 10.0.1415 / Virus Database: 2102/4060 - Release Date: 12/06/11
>>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|