Amps
[Top] [All Lists]

Re: [Amps] AL-1500 Plate Meter Circuit

To: "Jim W7RY" <w7ry@inbox.com>, <amps@contesting.com>
Subject: Re: [Amps] AL-1500 Plate Meter Circuit
From: "Dave Hachadorian" <k6ll@arrl.net>
Reply-to: Dave Hachadorian <k6ll@arrl.net>
Date: Thu, 23 Dec 2010 14:24:24 -0700
List-post: <amps@contesting.com">mailto:amps@contesting.com>
Page 9 of the instructions says, "The final grid current should 
be around 50 mA and the plate current below 1000 mA."

By the way, the power output meter in the AL-1500 is not a real 
wattmeter, and can be quite inaccurate.


Dave Hachadorian, K6LL
Yuma, AZ



-----Original Message----- 
From: Jim W7RY
Sent: Thursday, December 23, 2010 2:07 PM
To: Jim W7RY ; AMPS
Subject: Re: [Amps] AL-1500 Plate Meter Circuit

Looking a little closer at the schematic, R3 and R4 are grid 
meter
resistors.  The grid current is very low about 50 ma for 1500 
watts out.

Thanks
73
Jim W7RY



--------------------------------------------------
From: "Jim W7RY" <w7ry@inbox.com>
Sent: Thursday, December 23, 2010 1:04 PM
To: "AMPS" <amps@contesting.com>
Subject: [Amps] AL-1500 Plate Meter Circuit

> Merry Christmas!
> I'm working on a AL-1500. I noticed that the is only one 1.5 
> Ohm resistor
> in the plate metering circuit. The schematic calls for two 1.5 
> Ohm
> resistors (R3 and R4).
>
> The plate current seems just a bit high. With 1500 watts out, 
> plate
> current is about 975 ma @ 2900 volts. I really believe the amp 
> is a bit
> more efficient than this.
>
> Ideas?
> Thanks
> 73
> Jim W7RY
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
>
> -----
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 10.0.1170 / Virus Database: 1435/3333 - Release Date: 
> 12/23/10
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps 

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>