In a right built amplifier one would not use series connected electrolytic
caps in the power supply.
Individual, adjustable bias for what reason?
How do you bias for best IMD with more then one tube?
One tube is enough.
73
Peter
-----Original Message-----
From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com] On
Behalf Of Jim Thomson
Sent: Dienstag, 23. März 2010 03:31
To: amps@contesting.com
Subject: [Amps] How much C in PS is too much ?
Date: Mon, 22 Mar 2010 09:51:52 -0700
From: "Bill, W6WRT" <dezrat1242@yahoo.com>
Subject: Re: [Amps] how much C in PS is too much?
ORIGINAL MESSAGE:
On Sun, 21 Mar 2010 12:11:21 -0800, "Zeitler, Lane LT, FST-1"
<zeitlel@cpr3.navy.mil> wrote:
>at more or less
>1250uF total capacitance. Is this too much?.
REPLY:
>From a good engineering point of view, you should use just enough
capacitance so that adding more makes no audible difference at the
receiving end. This is a subjective judgment of course, but for a
typical 3 kV, 850 mA supply, that is about 50 uF. Some commercial maps
(Command) use as little as 35 uF so the value is not really critical,
obviously. But I wouldn't stray too far from those values.
73, Bill W6WRT
## after actually doing it now for 3 yrs... I'd say you want a MAX of 1%
ripple.
To pull that off on a typ 3 kv @ 800 ma supply, requires 8 x 600 uf caps..or
75 uf. Now if the supply is a FWDoubler, I'd use even more. The caps in
any doubler have to hold their charge twice as long as a FWB.
## I wouldn't be holding Command or anybody else up as any kind of
'standard of engineering excellence.' If these ham amps were built right,
they would all have individual, adjustable bias for each tube, plus mating
metering, real bandswitch's and real tank coils, and plate xfmrs... and
maybe
toss in a real tube..... and not something with a floozy 4 watt delicate
grid.
Jim VE7RF
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|