From: "Zeitler, Lane LT, FST-1" <zeitlel@cpr3.navy.mil>
Subject: Re: [Amps] 91B problem in Paraguay
In the past when I have had similar symptoms it was the plate xmfr shorted.
Both of these instances were Henry desktop amps, one a 1KD-5 and the other a
2KD-5. You need to start unloading, ie, unload the secondary of the plate xmfr
and see if it still blows fuses.
Lane
Ku7i
### Was the FWB rectifier assy shorted.. or just the plate xfmr pri/sec ?
A shorted fwb would lay a dead short across the sec of the plate xfmr.
If the xfmr was actually shorted, this makes henry radio plate xmfr
horror story #38 and #39. Henry radio has gone through at least 4-5 plate
xfmr manufacturer's I know of. They dumped ECA on the 8 k ultra... and went
to someone else... then the 8 k was discontinued.
Subject: [Amps] 91B problem in Paraguay
Turned on my hosts amp this morning and tripped the 2amp slow-blow fuse...Got
more fuses this afternoon and same thing keeps happening.
?
Seemed to shut down normally althought there may have been a problem with a
sticky T/R relay before turning off the amp.
?
Any ideas what could be causing the 2 amp fuses to blow when turning on the
switch?
## The 2 A slo blow is part of the step start circuitry. If their is a
short in the sec, or fwb, etc, the 2A fuse will blow. If the step start
resistor opened up, and the wide open resistor was shorted, the 2A fuse would
also blow.
Later... Jim VE7RF
?
Thanks
?
Dale ZP6/N3BNA
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|