That is not a good ider.Most of the P/O
couplers are not for measurement.
Please view the manual of G3SEK's
tetrode board,I think you can find want you want
73!Hsu
----- Original Message -----
From: "Allan Greening" <vk3pa@vk3pa.com>
To: <amps@contesting.com>
Sent: Sunday, January 04, 2009 7:13 AM
Subject: [Amps] measurement of Screen grid current
> Has anyone used a AC photo-optocupler like PC8144 to measure both forward
> and reverse curent flow in a "Tetrode" (4CX1000A) ..screen grid supply??
> say p/o coupler across a 1 ohm/6w resistor in the Sg line es the p/o
> feeding a LED bar readout.. yes i know u wont know if its + or - current
> flow but so wot as long as their is min current flow at tx'n!! de vk3pa
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|