Jason Buchanan wrote:
>The Dayton 4C761 fan is rated at 50CFM, 2840RPM, 115VAC 60hz. If you
>reduced the input voltage i'm sure it would handle the 50Hz AC. You'd
>probably want to do this since this fan pushes a lot of air and is a
>little noisy.
>
>
Ok, I couldn't resist. I had to plug it in and play with it.
It's not as loud as I thought. With a bit of back pressure it's fairly
quiet actually. I would say it's a tad louder than the AL-811 I have,
but the AL-811 cabinet resonates at a lower pitch (guessing 500hz) where
this little fan has a higher pitch (guessing 900hz).
The intake of the squirrel cage Dayton fan is the same diameter as the
hole in the L4 - a couple small screw holes drilled in the L4 chassis
and some self-tapping screws will hold it nicely. You'd probably want
to isolate it with some rubber washers.
regards,
Jason
--
Jason Buchanan - Boxboro, MA
Website: http://n1su.com/
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|