If maximum power transfer does not occur at I-peak, then what happens?
>
>not exactly.
>-----Original Message-----
>From: Rich <2@vc.net>
>To: "wl fuqua" <wlfuqu00@uky.edu>, "AMPS" <amps@contesting.com>
To: <amps@contesting.com>
>Date: Wed, 30 Oct 2002 05:52:50 -0800
>Subject: Re: [Amps] Distortion
>
>the critical moment is I-peak when anode conduction is maximal.
>
>>Should it not be the dynamic plate impedance instead of static plate
>>impedance???
>>And consider the conduction angle as well?
>>Which is nether of these.
>>73
>>Bill wa4lav
>>
>>At 01:05 AM 10/30/02 -0800, you wrote:
>>
>>
>>> >Lets say our rippy doo amp is running 5 kv plate AB2 GG. The plate
>>> >Z = about 12.5K at idle current..Now at "berserko speech", as Rich
>>> >would say, 1 amp of plate current the plate Z = 3.125k. What's up
>>> >with the output spectrum??? How do I match to this thing??
>>> >What plate Z should I design around??? Near as I can see it
>>> >varies from >12k to < 3k over the speech envelope!!
>>> >
>>>The Z at max I-cathode is the one that counts.
>>>
>>>
>>>- Rich..., 805.386.3734, www.vcnet.com/measures.
>>>
>>>_______________________________________________
>>>Amps mailing list
>>>Amps@contesting.com
>>>http://lists.contesting.com/mailman/listinfo/amps
>>
>>
>
>
>- Rich..., 805.386.3734, www.vcnet.com/measures.
>
>_______________________________________________
>Amps mailing list
>Amps@contesting.com
>http://lists.contesting.com/mailman/listinfo/amps
>
>
>
- Rich..., 805.386.3734, www.vcnet.com/measures.
|