| To: | <amps@contesting.com> |
|---|---|
| Subject: | [Amps] Use of Regulated DC on Power Tubes Filaments |
| From: | ToddRoberts2001@aol.com (ToddRoberts2001@aol.com) |
| Date: | Wed, 9 Oct 2002 11:24:00 EDT |
<PRE>If DC was bad for tube filaments, why didn't all the R-392 receivers made for the military self-destruct? These receivers were designed to run off of 24 VDC for BOTH filaments and plates. 73 Todd WD4NGG . |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [Amps] DC On tube filaments, MorgusMagnificen@aol.com |
|---|---|
| Next by Date: | [Amps] DC On tube filaments, Randall DuCharme |
| Previous by Thread: | [Amps] Use of Regulated DC on Power Tubes Filaments, Ron |
| Next by Thread: | [Amps] FS: Alpha 374A Project Amp, Terry Gaiser |
| Indexes: | [Date] [Thread] [Top] [All Lists] |