Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Topband\:\s+Receive\s+ant\s+question\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Topband\:\s+Receive\s+ant\s+question\s*$/: 8 ]

Total 8 documents matching your query.

1. Topband: Receive ant question (score: 1): Author: Its from Onion <aredandgold@msn.com>; Date: Tue, 25 Oct 2011 05:40:19 +0000; I'm looking to build and install my first beverage receive antenna. I use a 756 Pro and wondering a couple questions from folks who have been there. 1. Do I need a pre-amp and if yes your suggestion.; /archives//html/Topband/2011-10/msg00189.html (6,906 bytes)
2. Re: Topband: Receive ant question (score: 1): Author: W0MU Mike Fatchett <w0mu@w0mu.com>; Date: Tue, 25 Oct 2011 09:11:20 -0600; If the receive antenna is close to your transmit antenna then you will want to think about front end protection in a radio that has two receivers. Most single receiver radios should be shorting the r; /archives//html/Topband/2011-10/msg00194.html (7,796 bytes)
3. Re: Topband: Receive ant question (score: 1): Author: "Mark Beckwith" <n5ot@n5ot.com>; Date: Wed, 26 Oct 2011 08:27:00 -0500; I think a front end protector is some good amount of insurance. I listen on other receivers while transmitting. I have cooked an IC746PRO doing this and it was quite annoying. It tricked me into thin; /archives//html/Topband/2011-10/msg00199.html (7,788 bytes)
4. Re: Topband: Receive ant question (score: 1): Author: Rik van Riel <riel@surriel.com>; Date: Wed, 26 Oct 2011 17:32:18 -0400; With the RX antenna a reasonable distance (>100ft) away from the TX antenna, would an RF limiter (like the one ICE makes) be an acceptable substitute for a front end protector with relays? I am runni; /archives//html/Topband/2011-10/msg00202.html (7,463 bytes)
5. Re: Topband: Receive ant question (score: 1): Author: Eddy Swynar <deswynar@xplornet.ca>; Date: Thu, 27 Oct 2011 10:47:18 -0400; Hi Rik, I can only share my own personal experience here with you, for what it's worth... First-off, I use TWO old transceivers for 160-meters, i.e. a Yaesu FT-980, & an Icom 751A. I use them (separa; /archives//html/Topband/2011-10/msg00204.html (8,750 bytes)
6. Re: Topband: Receive ant question (score: 1): Author: wb6rse1@mac.com; Date: Thu, 27 Oct 2011 13:32:44 -0700; With the RX antenna a reasonable distance (>100ft) away from the TX antenna, would an RF limiter (like the one ICE makes) be an acceptable substitute for a front end protector with relays? I am runni; /archives//html/Topband/2011-10/msg00205.html (8,056 bytes)
7. Re: Topband: Receive ant question (score: 1): Author: Jon Zaimes AA1K <jz73@verizon.net>; Date: Fri, 28 Oct 2011 09:17:52 -0400; for the years I used a TS-940S, which was prone to picking up RF on a Beverage plugged into the RX-only input, I used a simple $2.00 Radio Shack SPST reed relay to short out the coax at the back of t; /archives//html/Topband/2011-10/msg00206.html (7,736 bytes)
8. Re: Topband: Receive ant question (score: 1): Author: Mike Waters <mikewate@gmail.com>; Date: Fri, 28 Oct 2011 09:13:54 -0500; You can't beat Barry's 'front end saver' at http://n1eu.com for a combination of simplicity and effectiveness. Two back-to-back diode strings (four 1N914 diodes per string) and a series 22 ohm resist; /archives//html/Topband/2011-10/msg00207.html (8,252 bytes)

Current List: 1 - 8
Page: [1]