First time poster so please excuse if I do not do this correctly: Rotating Tower I know bigger is always bigger than smaller due to possibly having to add items *(Box size)* I will have 7/8 " cell fl
Question: For those that have used what is commonly referred to depending on discussion poly rod, fiber glass rod, Fiber protrusion rod, etc. in lieu of ehs or phillystran what is the recommended ten
Want to attach 1/2" and or 7/8" hard line to Rohn tower specifcally Rohn 55 on one tower face horizontal brace or the tower leg and want to know if anybody has done this with brackets or some sort o
If not doing a large quantity and you have the luxury of having a good local machine shop quite possibly they could do what you want. I know locally I have a such a shop and they have always enjoyed
You may want to try and obtain the assistance of a roll on roll off wrecker type truck. I had my local mechanic meet me at a location to remove a US tower I had taken down and layed on the ground alo
Hi Paul, you may want to check the links provided below. I used something similar to these links (there are others) to have large items such as what you are dealing with shipped to my location. I did
Just a thought about pulling existing section out with excavator most likely may have to dig around the existing hole/concrete, etc. and pull out cause I would think attaching cable/chain/straps to e
Just a thought about pulling existing section out with excavator most likely may have to dig around the existing hole/concrete, etc. and pull out cause I would think attaching cable/chain/straps to e
Thought I would share some knowledge I gained in a recent rework/refurbishing on two thrust bearings I had in my inventory. The two bearings were a Rohn TB3 and Rohn TB4 which I had acquired some tim
Need the correct way to do this. In my search efforts could not find any documentation involving this issue. Having installed and taken down various tower installs in the past I am about to do a inst
I would like to hear from those in regards to ideas for the following. I know there are those who have long runs of control cabling for rotation, switching, etc. so I seek your ideas and advice. I ha
Hi Mark my small metal caliper measures at 1 and 7/8" or 27mm....if it is off it only by 1mm according to my handy little caliper. If others respond hopefully they confirm what I have provided. Charl
Ugh! Correction, reading the mm wrong, it looks like it should be 59mm! sorry about that! Charles "Ed' K5OF Hello group! Could someone here give me the precise inside diameter of this bearing? Quick
Al is correct! Thank you Al for the correction...Doufus me was reading a scale that had it broken down into 1/32" so Al should have it right! Carry on everybody and good luck Mark! Charles "Ed" K5OF
Not too long ago there was a posting on a topic and there was the mention of cable ties for securing coax and control lines to tower legs on the runs. It was the part of a overall discussion unrelat
Hi Jim and others who may need the following info. I speak with experience. I have some rings for 55G and a tower project that has been in the works with setbacks due to hurricanes and other storms,
IMO can't go wrong with the Balun Design products. Nice selection, support, well worth the investment from what I believe is a quality product. Nothing negative about W2DU product so cannot speak to
Hi Wilson, try the link provided below for extensive information that may help answer some of your questions. Norms Rotor Service has been around a long time and he knows his stuff. Good luck and 73!