- 1. [Towertalk] Greenlee punch question (score: 1)
- Author: ke3q@msn.com (RICHARD BOYD)
- Date: Thu, 16 Jan 2003 23:40:24 +0000
- Any ideas on a good or the best way to get the "chad" out of the Greenlee punch after punching a hole? I'm making a single point ground incoming coax bulkhead out of a sheet of copper. By the way, I
- /archives//html/Towertalk/2003-01/msg00292.html (7,332 bytes)
- 2. [Towertalk] Greenlee punch question (score: 1)
- Author: dhearn@ix.netcom.com (Dan)
- Date: Thu, 16 Jan 2003 16:35:02 -0800
- Richard: The BW you describe means one thing to me, serious loss resistance in the vertical, probably in the ground system. Re the Greenlee punch, I usually unscrew the bolt several turns then tap th
- /archives//html/Towertalk/2003-01/msg00293.html (8,850 bytes)
- 3. [Towertalk] Greenlee punch question (score: 1)
- Author: k4oj@tampabay.rr.com (Jim White, K4OJ)
- Date: Thu, 16 Jan 2003 19:45:35 -0500
- rake next size up diameter wise screw- or tap - thread it into the "Chad" - be careful not to "Gore" it - then pull out.... K4OJ
- /archives//html/Towertalk/2003-01/msg00294.html (8,466 bytes)
- 4. [Towertalk] Greenlee punch question (score: 1)
- Author: mark@concertart.com (Mark Beckwith)
- Date: Thu, 16 Jan 2003 19:27:13 -0600
- Gosh, I just did this at N5OT. I backed the bolt all the way out, recovered the punch, then set my vise so the jaws were farther apart than the diameter of the punch but not as far out that the die
- /archives//html/Towertalk/2003-01/msg00297.html (7,619 bytes)
- 5. [Towertalk] Greenlee punch question (score: 1)
- Author: ka9wyk@hotmail.com (Carl Demmin)
- Date: Fri, 17 Jan 2003 08:47:04 -0600
- I have been using the punches for years and what I do is make sure the punch is lubed and have a good screw driver handy to get the material out of the punch. I use a spray lube like wd-45 and it hel
- /archives//html/Towertalk/2003-01/msg00307.html (7,439 bytes)
This search system is powered by
Namazu