All, I called Fulton and asked if the bolt pattern on their K2550 winch was the same as the K1550. The tech said it was close, but not a match. I know that more than one member of this reflector has
Take a look at the Dutton-Lainson DLB2500A. I just purchased one from Amazon.com and it was a "snap" to install in the existing holes. -- Tnx es 73 Richard W7ZR www.w7zr.com *Be joyful in hope, patie
I use the SA9000AC, without clutch on my hg 70 hd Buster kg9nd ________________________________ From: Richard Zalewski <dick.w7zr@gmail.com> To: Tony <dxdx@optonline.net> Cc: towertalk@contesting.co
It not a big problem to re drill the plate with a new pattern. I find that one of the of the holes will line up. Just use a small pilot hole then drill the bigger holes. I used the Thern with the a 4
The slotted holes on the K2550 I bought a few years back lined up just fine with the holes on the TRX80. The holes may not be the same on the two winches, but the slots may be long enough to make for
Not knowing how different they are, I'd set the winch on the mounting plate, mark the holes, then drill and tap a new set...if there's room. If not, make an adapter plate out of 1/4 to 1/2" steel or