- 1. [TowerTalk] Hy-Gain HG70HD thrust bearing (score: 1)
- Author: Ken Alker <ka6ken@alker.net>
- Date: Sat, 15 May 2021 07:56:22 -0700
- Hi, I recently acquired a Hy-Gain HG70HD tower. I hired a crane operator to lift the mast/antenna assembly off the tower and then had the tower lifted out of the back yard and placed horizontally on
- /archives//html/Towertalk/2021-05/msg00060.html (9,086 bytes)
- 2. Re: [TowerTalk] Hy-Gain HG70HD thrust bearing (score: 1)
- Author: "kj6y \(null\) via TowerTalk" <towertalk@contesting.com>
- Date: Sat, 15 May 2021 21:59:19 -0700
- That is the whole bearing. The collar sits on top of the plate. Use some grease between the collar and plate. Skip, KJ6Y 818-522-5421 Communications Service Co Sent from my IPad Hi, I recently acquir
- /archives//html/Towertalk/2021-05/msg00061.html (9,701 bytes)
- 3. Re: [TowerTalk] Hy-Gain HG70HD thrust bearing (score: 1)
- Author: Ken Alker <ka6ken@alker.net>
- Date: Sun, 16 May 2021 09:35:34 -0700
- Thanks to everyone for the help and suggestions! I was pretty convinced that there should be some kind of rolling bearing assembly in the gap between the bottom of the collar and the "seat" inside th
- /archives//html/Towertalk/2021-05/msg00062.html (13,085 bytes)
- 4. Re: [TowerTalk] Hy-Gain HG70HD thrust bearing (score: 1)
- Author: k7lxc--- via TowerTalk <towertalk@contesting.com>
- Date: Mon, 17 May 2021 19:10:03 +0000 (UTC)
- _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk
- /archives//html/Towertalk/2021-05/msg00063.html (7,451 bytes)
This search system is powered by
Namazu