Mail Archive Search: <+from:tgstewart@pepco.com>

Results:

References: [ +from:tgstewart@pepco.com: 91 ]

Total 91 documents matching your query.

61. [TowerTalk] Coax in Conduit and WATER! (score: 1): Author: tgstewart@pepco.com (tgstewart@pepco.com); Date: Mon, 7 Jul 1997 09:04:11 -0400; -- Forwarded by Tyler G Stewart/BENN/CEC on 07/07/97 09:04 AM -- Tyler G Stewart 07/07/97 09:03 AM While I direct-buried my hardlines to my first tower, I also buried a length of the 4" corrigated dr; /archives//html/Towertalk/1997-07/msg00243.html (12,553 bytes)
62. [TowerTalk] Galvanized ground rod connector (score: 1): Author: tgstewart@pepco.com (tgstewart@pepco.com); Date: Fri, 11 Jul 1997 07:17:05 -0400; Cadweld's are the best way to go. I'm not sure if they make the inexpensive One-Shot's for EHS ground wire or not, but last time I checked, RF Connection had them in their catalog, so you might give; /archives//html/Towertalk/1997-07/msg00397.html (8,330 bytes)
63. [TowerTalk] (Fwd) Re: tape differences (score: 1): Author: tgstewart@pepco.com (tgstewart@pepco.com); Date: Mon, 28 Jul 1997 09:47:44 -0400; -- Forwarded by Tyler G Stewart/BENN/CEC on 07/28/97 09:16 AM -- I have to believe there is more to it than just thickness. 88 is available in different thicknesses as well. Super 88 is thinner than; /archives//html/Towertalk/1997-07/msg00786.html (9,175 bytes)
64. [TowerTalk] Big soldering irons (score: 1): Author: tgstewart@pepco.com (tgstewart@pepco.com); Date: Tue, 10 Jun 1997 08:36:51 -0400; Well, if you dont mind spending around $100, the real deal is one of the butane powered pencil irons from Master Appliance. They make 3 different sizes. The larger two are usually adequate for PL259'; /archives//html/Towertalk/1997-06/msg00322.html (9,712 bytes)
65. [TowerTalk] Big soldering irons (score: 1): Author: tgstewart@pepco.com (tgstewart@pepco.com); Date: Tue, 10 Jun 1997 08:52:38 -0400; Just be careful on silver bearing solder...most of it comes with acid flux, which is a definite no-no for electronic use. It's really much better suited to mechanical soldering applications as it's m; /archives//html/Towertalk/1997-06/msg00324.html (10,187 bytes)
66. [TowerTalk] yagi comments (score: 1): Author: tgstewart@pepco.com (tgstewart@pepco.com); Date: Mon, 16 Jun 1997 15:19:32 -0400; This is all very interesting...but what we really need is an independent third-party analysis of what happens to both of these philosophies when loaded with 1/2" radial ice and a little wind comes al; /archives//html/Towertalk/1997-06/msg00520.html (14,700 bytes)
67. [TowerTalk] Heights Towers resurfaces (score: 1): Author: tgstewart@pepco.com (tgstewart@pepco.com); Date: Tue, 17 Jun 1997 08:34:59 -0400; Just wanted to say that I really like all the info you are putting into the CQ Contest magazine! Your column this month on some of the most popular tower types/models is very good as is the "Monthly; /archives//html/Towertalk/1997-06/msg00553.html (8,086 bytes)
68. [TowerTalk] CATV Hardline connectors (score: 1): Author: tgstewart@pepco.com (tgstewart@pepco.com); Date: Tue, 24 Jun 1997 08:51:00 -0400; The most elegant method is to use CATV connectors slightly modified. I use CATV Pin connectors with "B-body", 50 ohm N connectors screwed on the end. This is the real deal. This gives you the waterti; /archives//html/Towertalk/1997-06/msg00808.html (15,020 bytes)
69. [TowerTalk] CATV Hardline connectors (score: 1): Author: tgstewart@pepco.com (tgstewart@pepco.com); Date: Tue, 24 Jun 1997 17:09:11 -0400; I disagree. Of course, I'm running only 1.5kw RTTY output, not 10kw or more. :) If you stick with the PIN connectors that are specifically made for your cable (ie. just having a 3/4 inch connector fo; /archives//html/Towertalk/1997-06/msg00824.html (20,157 bytes)
70. [TowerTalk] Hardline (score: 1): Author: tgstewart@pepco.com (tgstewart@pepco.com); Date: Tue, 24 Jun 1997 17:36:45 -0400; You can almost bet it's CATV cable...Commscope is a HUGE supplier of CATV cable. If its uncorrigated witha solid aluminum outer conductor and a copperclad aluminum inner conductor, you can bet it's C; /archives//html/Towertalk/1997-06/msg00826.html (8,115 bytes)
71. [TowerTalk] How Important is F/B? (score: 1): Author: tgstewart@pepco.com (tgstewart@pepco.com); Date: Thu, 26 Jun 1997 08:05:31 -0400; Everything you talk about has been debated before and there are no easy answers. However, I'd pick the KT34XA over the TH7. It's a little bigger antenna, probably a little more gain. The pattern is s; /archives//html/Towertalk/1997-06/msg00898.html (11,114 bytes)
72. [TowerTalk] 40-2CD Spacing and Interactions with WARC? (score: 1): Author: tgstewart@pepco.com (tgstewart@pepco.com); Date: Thu, 1 May 1997 08:56:44 -0400; I concur that the 402CD is resonant around 18mhz as a third harmonic rather than 21mhz because of the loading. It's not a half-bad antenna on that band. I can guarantee you will have at least some in; /archives//html/Towertalk/1997-05/msg00012.html (8,841 bytes)
73. [TowerTalk] 45vs.55G (score: 1): Author: tgstewart@pepco.com (tgstewart@pepco.com); Date: Mon, 5 May 1997 07:55:35 -0400; -- Forwarded by Tyler G Stewart/BENN/CEC on 05/05/97 07:45 AM -- Not necessarily. You could probably get away with 2 sets of guys instead of 3, but check the Rohn Catalog for details. If you are buyi; /archives//html/Towertalk/1997-05/msg00121.html (8,217 bytes)
74. [TowerTalk] R45 top prompted by Leeson comment (score: 1): Author: tgstewart@pepco.com (tgstewart@pepco.com); Date: Mon, 5 May 1997 08:06:15 -0400; I sincerely doubt this is a problem. I'm no engineer, but since it is only the last couple of feet and there is no twisting force at the very top of the tower, there really is no reason for them. Rem; /archives//html/Towertalk/1997-05/msg00122.html (8,517 bytes)
75. [TowerTalk] KLM-34XA insulator problems ? (score: 1): Author: tgstewart@pepco.com (tgstewart@pepco.com); Date: Mon, 5 May 1997 08:27:40 -0400; This was only a problem with the earliest cap tube insulators, which were clear and probably polystyrene. The latest ones are blue and I've not seen any deterioration on them. KLM did recently redo t; /archives//html/Towertalk/1997-05/msg00123.html (8,616 bytes)
76. [TowerTalk] KT34XA cracked insulators (score: 1): Author: tgstewart@pepco.com (tgstewart@pepco.com); Date: Mon, 5 May 1997 10:24:03 -0400; One thing to watch out for on these blue insulators is voids on the inside surface which contacts the 3/8" tube. I've found a significant number of new ones to have pockets which could allow a lot of; /archives//html/Towertalk/1997-05/msg00126.html (12,034 bytes)
77. [TowerTalk] 45G top plates (score: 1): Author: tgstewart@pepco.com (tgstewart@pepco.com); Date: Tue, 6 May 1997 09:06:52 -0400; OK, but most of us dont try and overload 45G like you do :) IMHO, if your tower cant survive easily with the guys ten feet from the top, you should be using heavier tower anyway. But if you do that,; /archives//html/Towertalk/1997-05/msg00148.html (9,093 bytes)
78. [TowerTalk] 45G top plates (score: 1): Author: tgstewart@pepco.com (tgstewart@pepco.com); Date: Tue, 6 May 1997 16:10:43 -0400; My next question would be how much mast did he have inside the section and how was it supported? IE, was it just stuck inside the top tube of a regular top section or was it supported below the tube; /archives//html/Towertalk/1997-05/msg00160.html (8,672 bytes)
79. [TowerTalk] Orion rotors (score: 1): Author: tgstewart@pepco.com (tgstewart@pepco.com); Date: Mon, 12 May 1997 11:42:01 -0400; I'm no Orion expert, but at least the 2300 and 2800 do not have a directional pot. They use a reed switch and magnet on a flywheel approach to count turns. Some ferrite beads at intervals around your; /archives//html/Towertalk/1997-05/msg00319.html (9,010 bytes)
80. [TowerTalk] Orion rotors (score: 1): Author: tgstewart@pepco.com (tgstewart@pepco.com); Date: Mon, 12 May 1997 15:44:40 -0400; OK. I got my "2300" used and it's the digital version, which I guess abandons the pot method. Thanks for the info! 73, Tyler Please respond to w8mm@ibm.net approach > to count turn Hi Tyler! My Orion; /archives//html/Towertalk/1997-05/msg00324.html (7,810 bytes)

Current List: 61 - 80
Page: [1] [2] [3] [4] [5]