Alphabetical has always worked to me! Bob W7KD _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://l
I used the TH-6 antenna for many years and was very pleased with it in every way. It has been said that the TH-6 was probably the best tri-bander ever made in its time. I do have a four page paper ca
Ah, the dragon has raised his head breathing fire. hi hi Bob W7KD _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@cont
Again...has anyone modeled one of these things? To me it looks to be variant of a vertically polarized yagi. Bob W7KD _______________________________________________ _________________________________
Amen! And praise the Lord for the "delete" key... Bob W7KD _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.
hi hi _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towe
The newer Hy-Gain Tail Twister rotor uses the nine pin round black plastic plug made by AMP 73 Bob W7KD _______________________________________________ _______________________________________________
Whoa! $200 for a Tail Twister would a steal...with or without being serviced. I'll take it. Bob W7KD _______________________________________________ _______________________________________________ To
Can this dialogue be continued elsewhere, like perhaps to a more appropriate LP reflector? _______________________________________________ _______________________________________________ TowerTalk ma
I have had about the same experience in the past with a full wave delta loop on 80 meters. The loop was sloped at 45 degrees and fed at the bottom corner. Worked great for me. Did a lot of A/B compar
With the potential problems with galling with stainless u-bolts why not use galvanized? Just curious! Bob W7KD _______________________________________________ ________________________________________
You can find a page on the conversion in a current version of the Hy-Gain 204BAS manual. Bob W7KD _______________________________________________ _______________________________________________ Tower
No worries! Hose clamps work real good too... hi hi Bob W7KD Wonder why donīt you upgrade and insert a good stainless steel screw with nuts instead those failing rivets. Optibeam is using this system
Unfortunately this thread will be back in a couple months...it always does! _______________________________________________ _______________________________________________ TowerTalk mailing list Towe
...and I believe the rotor may be a newer Hy-Gain Ham 4, being that it has the short pigtail control cable interface with the taped up eight pin Jones plug. 73 de Bob W7KD ___________________________
Google ? _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/t
Will a Tail Twister T2X rotor work in a Rohn 25 tower? Any thoughts and/or opinions would be appreciated. Thanks for your help. Bob W7KD _______________________________________________ ______________