Yeah, snagged the last one. 73, Allen R. Brier N5XZ 1515 Windloch Lane Richmond, TX 77406 713-705-4801 --Original Message-- From: Steven Katz <stevek@jmr.com> Sent: Monday, July 22, 2024 3:51 PM To:
Looking to purchase a STEEL ring gear for a TailTwister Rotator. Anyone got one out there? 73, Allen R. Brier N5XZ 1515 Windloch Lane Richmond, TX 77406 713-705-4801 -- This email has been checked fo
[Sending this out again to just in case someone may have missed it.] Looking to purchase a STEEL ring gear for a TailTwister Rotator. Anyone got one out there? It is p/n 5136101. 73, Allen R. Brier N
I recently purchased an unused TailTwister rotator for $20(!). I have been using T2X's rebuilt by Norm's (I think) where the original terminal strip was replaced by a plug/socket. I am 'assuming' the
Thanks, Joe. I just got lucky! Allen R. Brier N5XZ 1515 Windloch Lane Richmond, TX 77406 713-705-4801 Find a manual with the pinouts for the connector at https://www.w2aee.columbia.edu/sites/default/
Years ago I got a Kellems Split Loom Grip for my tower installation from someone on TT. I'm doing some refurbishing and thought I might need to replace it.it's only been about 16 years or so. So does
Thanks to Seve Maki for that information and better pricing for split loop grips than Kellems... Turns out the sizes indicated do not reflect the actual OD/ID sizes. Had to go with an HG78 for my 1"
Hi, I'm trying to setup a Green Heron RT-20 for a Yaesu G-2800 rotator. As part of the setup, I noticed a Max Speed parameter = AC MOTOR (Value = 11). The Yaesu is a DC motor. Why is AC MOTOR one of
I'm looking to installed an 80m loading coil in my 18HT tower to use for CW and FT8 and which will handle at least 1KW (FLL would be better). Not sure if anything is still available from MFJ but can
Hi Skip, I looked on the HI-Q website and didnt see any option to purchase the coil separately. 73/161, Allen R. Brier N5XZ 1515 Windloch Lane Richmond, TX 77406 USA 713-705-4801 From: kj6y@aol.com <