All, I have an earlier model E-Z Way RBZ-75-3 Tower that I am planning on installing early next year. I have been searching the net for any information I can locate on this tower with limited success
All, As I am working on rounding up the necessary information to install my E-Z Way RBZ-75 Tower, I am in need one an additional bit of information. I am missing the tilt over winch, and have not fou
All, I have stacked many a section of Rohn 25, and the method I have settled upon is as follows. I actually use a set of Kline cable grips to grasp the cable, but any of the previously mentioned meth
All, I will be putting up a tower in the next few months, and an finalizing the antenna system I want to put on top. I already have a TH-11DX that will be the main antenna for the upper HF bands, and
Doug, thanks for the reply. The approach I am wanting to use really is not much work. The extension of the boom is just the slip in piece of the th-6 boom. I already have to rebuild the truss cables,
Message: 5 Date: Sun, 24 Apr 2016 22:11:00 -0400 From: Les Kalmus <w2lk@bk-lk.com> To: TOWERTALK@contesting.com Subject: [TowerTalk] Lifting a mast off the rotator Message-ID: <bd4af790-fa6d-785f-b40
All, For a number of years, I have been living with some low level power line noise. It comes and goes usually depending on the weather. Rain usually clears it up for a few days to a week or more. La
Bill, Since the add on kit modifies the driven element, all you need to know is the overall length of the modification, then take 1/2 that length and that will be your new turning radius. I found a m
Les, You asked if there was a better method than the turkey baster for removing the residual oil in the bottom of the gear box, so I offer this suggestion. One of the shore-lander type of marine engi
All, I haven't seen anything on the reflector yet in regards to the newly signed into law aviation bill HR-636. H.R.636 - Federal Aviation Administration Reauthorization Act of 2016, which was signed
Sent from my HTC One on the Verizon Wireless 4G LTE network 3. Re: Strength of installation raising cable for the LM470 -- Message: 3 Date: Sun, 28 Aug 2016 05:02:03 -0400 From: "Steve \(K1IIG\)" <st
All, I'm looking for anyones experience with pulling a long (almost 400ft) length of 7/8" hardline in underground conduit. I have 4" conduit which will have a number of sweeps in it. Here's how it wi
I'll answer all in one post. This is a new installation. The feed line exits the radio room on the West wall, goes underground, through the house West foundation wall, through a little over 70ft of c