Don, MFJ does NOT sell the towers. ONLY the base for the tower...the rebar base and the ears for mounting the tower are attached/welded on. Any parts for the tower must be obtained from after market
A nine inch owl? What bird would be afraid of that? Down here in Florida the Osprey would just sit next to it and try to discuss insurance premiums with it. - Mike http://www.bitsandpieces.com/produc
I'm interested in the bulbs for the dial lamps... - Mike Read with voice of your favorite used car or ginzu knife salesman!!! BIG BLOWOUT SALE!!!! EVERYTHING MUST GO!!! Etc, etc, etc. well, they don'
Was the ORIGINAL question an inquiry about an LMR 600 clone or RG-213? These are quite different.... If the question was about an LMR 600 clone, what was the answer? - Mike The RF Connection has very
Does anyone know whether the connectors for a 1000 DXA rotor will fit the 450 A rotor? Are the connectors for all the Yaesu rotors the same (except for the 2800 I would assume). - Mike ______________
The instructions for the 450 rotator show a six pin plug for the control box and a SEVEN pin round connector that attaches to the actual motor drive unit. The instructions further say NOT to use pin
Best way to keep birds of the tower, dogs out of your yard, and door to door salesman away altogether is to post a recent picture of my mother-in-law somewhere near the tower. Preferably facing up. C
Thanks for the replies on this. The manual that I mistakenly downloaded was for a 450 XL rotor which is not the same as the 450 A. The 450 A manual directions are quite clear. Thanks especially to TO
I have used an HF2V here in southwest Florida for about 7 or 8 years. I ground mounted one with a fair amount of radials, no particular pattern, some long up to 100ft. some short to about 30ft. Total
Ultra sonic projectors or yelpers of one kind or another have been mentioned for ridding birds from towers. I have looked on-line and see a myriad of these things. I would like to buy one. Did I also
The tie wraps are a good idea...they most likely won't last a terribly long time in the Florida sun, but better than nothing. I will try them on my recv loop...it has been a popular perch for osprey
My friend is installing a tilt over fixture for his HyGain HG-70D crank-up tower. He is looking for a winch for the device, one that has the' grit' to handle the weight of course but also with the 'b
Jim, Looks like he is going to order the 2550 today. Thanks to all for the responses. '73, Mike I recently bought a used Tash tower LM470 and tilt fixture. It uses a Fulton K1550 winch. I also helped
I have a 12 element M2 2m beam that has been on the tower here for 10 years or more. Birds.. BIG ONES, osprey, owls, seagulls, mother-in-laws, have all been up there and many sit way out on the end.
Joe, A couple of years ago the local club here asked got some of the guys to participate in some kind of a Lighthouse Contest over a weekend...a few summers back. The reason I recall it was summer I
Does anyone know whether a T2X (Tailtwister) Rotor will fit without modification into a HyGain HG-70D crank-up tower? ...thanks. -Mike _______________________________________________ ________________
Excuse the test.... - m _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mai
Sounds similar to a Carolina Windom (off center fed dipole sold by the Radio Works). - Mike I just want to let you know how well my antenna works. I compare it to my other wire antenna a 135' doublet
Does anyone know what the center to center leg distance is for the legs of Rohn 25 tower? - Mike _______________________________________________ _______________________________________________ TowerT